next toy
After a reboot all works as expected and all the devices show also up with lsscsi.
root@debian:~# lspci -knn
...
04:00.0 RAID bus controller [0104]: Hewlett-Packard Company Smart Array G6 controllers [103c:323a] (rev 01)
Subsystem: Hewlett-Packard Company Smart Array P410i [103c:3245]
Kernel driver in use: hpsa
14:00.0 RAID bus controller [0104]: Hewlett-Packard Company Smart Array G6 controllers [103c:323a] (rev 01)
Subsystem: Hewlett-Packard Company Smart Array P212 [103c:3241]
Kernel driver in use: hpsa
root@debian:~# lsscsi
[0:0:0:0] storage HP P410i 3.52 -
[0:0:0:1] disk HP LOGICAL VOLUME 3.52 /dev/sda
[1:0:0:0] storage HP P212 3.52 -
[1:2:0:0] tape HP Ultrium 2-SCSI T65D /dev/st0
[3:0:0:0] cd/dvd ATAPI DVD A DH16AAS JHE5 /dev/sr0
Monitoring:
cciss-vol-status
und
hpacucli
root:~# ./hpraidinfo
Smart Array P410 in Slot 1
Bus Interface: PCI
Slot: 1
Serial Number: PACCR9VYJIN7
Cache Serial Number: PAAVP9SZ832X
RAID 6 (ADG) Status: Enabled
Controller Status: OK
Hardware Revision: C
Firmware Version: 2.72
Rebuild Priority: Medium
Expand Priority: Medium
Surface Scan Delay: 15 secs
Surface Scan Mode: Idle
Queue Depth: Automatic
Monitor and Performance Delay: 60 min
Elevator Sort: Enabled
Degraded Performance Optimization: Disabled
Inconsistency Repair Policy: Disabled
Wait for Cache Room: Disabled
Surface Analysis Inconsistency Notification: Disabled
Post Prompt Timeout: 0 secs
Cache Board Present: True
Cache Status: OK
Cache Ratio: 100% Read / 0% Write
Drive Write Cache: Disabled
Total Cache Size: 512 MB
Total Cache Memory Available: 400 MB
No-Battery Write Cache: Disabled
Battery/Capacitor Count: 0
SATA NCQ Supported: True
Smart Array P410 in Slot 1
array A
logicaldrive 1 (149.0 GB, RAID 1, Interim Recovery Mode)
Smart Array P410 in Slot 1
array A
physicaldrive 2I:0:5 (port 2I:box 0:bay 5, SATA, 160.0 GB, Failed)
physicaldrive 2I:0:6 (port 2I:box 0:bay 6, SATA, 160.0 GB, OK)
root#
root# ./hpraidstatus
Smart Array P410 in Slot 1
Controller Status: OK
Cache Status: OK
logicaldrive 1 (149.0 GB, RAID 1): Interim Recovery Mode
physicaldrive 2I:0:5 (port 2I:box 0:bay 5, 160.0 GB): Failed
physicaldrive 2I:0:6 (port 2I:box 0:bay 6, 160.0 GB): OK